Before Using Your Glue Gun…

To ensure the best performance from your applicator follow these tips:

1. Before use, ALWAYS allow the applicator to warm up to operating temperature.

2. Most applicators are ready in 5-7 minutes.

3. Spray applicators should be allowed to heat up for at least 10 minutes.

4. NEVER lay the applicator on it's side.

5. ALWAYS use the gun stand supplied or an optional stand for suspension hook if available.

6. ALWAYS unplug the applicator if it is not going to be used for 40 minutes or more.

7. To AID EASIER START UP the next time the applicator is used, disconnect from the power supply when work is complete and while the tool is cooling extrude about half a cartridge / stick of molten glue through the applicator.

8. NEVER withdraw a part melted glue slug / stick through the back of the gun.

9. NEVER remove the nozzle from a cold applicator as thread damage could result. Remove when warm and always wear protective gloves.

10. ALWAYS wipe any excess molten glue from around the nozzle at the end of each work session. This will avoid build up of glue deposits which can char. This should be done while the applicator is still hot and always wear protective gloves.

For more information please contact our sales office:
Tel: 0161 627 1001
Fax: 0161 627 5072
E: sales@gluegunsdirect.com

Challenge us, we can bond anything!